Timing belt replace 2000 saturn sl2

SOURCE: diagram of where the starter is located

Here ya go! (#5)

SOURCE: 1997 saturn sl2 dohc is there a timing belt or chain on it

These engines have a timing chain, not a belt. They also have nylon coated guides under the cover that wear. If you change the chain yourself, or have it done, check the guides as well.

SOURCE: 2000 Saturn SL2 - replaced ignition then BCM failed. Related?

the problem is not the bcm. the passlock security sensor is in the cylinder and housing, if the cyl and or housing was replaced the system must be relearned. if you replace the bcm you still need to relearn the system or it still will not start.

SOURCE: Where is the fuel filter on a 1997 Saturn SL2?

It is an inline fuel filter under the car in the frame rail up front neat the motor area. It will look similar to this...



On that saturn it has a hose already attached to the fuel filter. It has what they call quick connects on both sides. just remove one side of air intake. (the one closest to firewall of car) where you can get your arm in there. Reach right under fuel filter and grab two white or green tabs with pointer finger and thumb. and squeeze till they make a snaping noice. then all you have to do is reach under fuel filter and pull hose off. Then push the black clips around fuel filter out and it should slide out. The same on the hose already connected to the fuel filter

SOURCE: How do I replace the serpentine belt on my 2002

Take off, or loosen the front half of the wheel well. There will be 3 screws (7mm) and two trim clips There are two clips on the plastic piece just under the belt. Take those out, and you will have full access to the belt and the tensioner. The tensioner nut (so to speak) is 9/16, and cannot be accessed with a socket. Must use a wrench with a long handle. At that point, hook the wrench to the nut and turn it clockwise to loosen. Remove the belt, and replace it with a new one

Testimonial: "."