My 1996--windshield wipers,radio,cruise control and power windows. Dont work Is there a fuse that control all these that function ?

• REPLACEMENT

Fuse Block and Convenience Center

Print
See Figures 1 through 5
For 1988-93 models, refer to the wiring diagrams for fuse application and amperage ratings.
Fuses protect all the major electrical systems in the car. In case of an electrical overload, the fuse melts, breaking the circuit and stopping the flow of electricity.
The fuse block on most models covered by this section is located under the instrument panel to the left of the steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket.

Fig. Fig. 1: Some models may use an underhood fuse/relay panel
If the panel is not visible, check for a removable compartment door or trim panel which may used on later models to hide the block. This panel is usually located on the left end of the instrument panel.
The convenience center is located just below the instrument panel on the drivers side. It contains individual relays such as the seat belt and ignition key alarm, and flasher.
On newer model vehicles there is an underhood fuse/relay center contains both mini and maxi fuses, as well as some relays.
If a fuse blows, the cause should be investigated and corrected before the installation of a new fuse. This, however, is easier to say than to do. Because each fuse protects a limited number of components, your job is narrowed down somewhat. Begin your investigation by looking for obvious fraying, loose connections, breaks in insulation, etc. Use the techniques outlined at the beginning of this section. Electrical problems are almost always a real headache to solve, but if you are patient and persistent, and approach the problem logically (that is, don't start replacing electrical components randomly), you will eventually find the solution.
Each fuse block uses miniature fuses (normally plug-in blade terminal-type for these vehicles) which are designed for increased circuit protection and greater reliability. The compact plug-in or blade terminal design allows for fingertip removal and replacement.
Although most fuses are interchangeable in size, the amperage values are not. Should you install a fuse with too high a value, damaging current could be allowed to destroy the component you were attempting to protect by using a fuse in the first place. The plug-in type fuses have a volt number molded on them and are color coded for easyMy 1996--windshield wipers,radio,cruise control an - 0996b43f80219b57.jpgsure to only replace a fuse with the proper amperage rated substitute.

Fig. Fig. 3: The fuse panel cover is located at the drivers side of the instrument panel. Remove the panel to access the fuses-1996-98 models shown

Fig. Fig. 4: Fuse application and amperage ratings-1994-98 models. Refer to the wiring diagrams for 1988-93 models

Fig. Fig. 5: Underhood fuse/relay panel applications and ratings
A blown fuse can easily be checked by visual inspection or by continuity checking.
A special heavy duty turn signal flasher is required to properly operate the turn signals when a trailer's lights are connected to the system.

REPLACEMENT

1. Locate the fuse for the circuit in question.

1. Check the fuse by pulling it from the fuse block and observing the element. If it is broken, install a replacement fuse the same amperage rating. If the fuse blows again, check the circuit for a short to ground or faulty device in the circuit protected by the fuse.
2. Continuity can also be checked with the fuse installed in the fuse block with the use of a test light connected across the 2 test points on the end of the fuse. If the test light lights, replace the fuse. Check the circuit for a short to ground or faulty device in the circuit protected by the fuse.