Put on a new timing belt, new camshaft position sensor, crankshaft sensor and new engine coolant temp sensor but now it is still showing bad engine coolant temp sensor
SOURCE: Crankshaft Position Sensor location 04 PT Cruiser
It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.
SOURCE: 2002 pt cruiser Camshaft Sensor
change the crankshaft positon sensor in the rear of the engine above the oilfilter. Also check the wiring to this sensor, they have a problem shorting out. You have to change the camshaft and crankshaft sensors at the same time. Make sure you give your car a major tune up. Did you check yor starter?.........runjoe
SOURCE: schema the timing for pt cruiser 2003 touring motor 2.4
2.4L timing belt installation and timing marks. Hope this helps.
SOURCE: error code P0335 (2005 pt cruiser)
p0335 is crankshaft position sensor circuit fault code..possible just a faulty sensor,shouldn't set a circuit code if timing is off..a sensor is probably around a 100 bucks..located just above starter in block
SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...
GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP
1,099 views
Usually answered in minutes!
×