3894860N checking numbers

In a 2014 Toyota RAV4, you can typically find the engine number stamped on the engine itself. Here's where you can commonly locate it:

1. Engine Block: The engine number is often stamped or engraved on the engine block. You may need to look around the engine block, typically on the front or sides, near the cylinder head or the engine mount.
2. Owner's Manual: Sometimes, the engine number is recorded in the vehicle's owner's manual or maintenance booklet. Check these documents to see if the engine number is listed.
3. Vehicle Registration Documents: In some regions, the engine number may be recorded on the vehicle registration documents or title. Check these documents for the engine number if it has been previously documented.
4. Under the Hood: Occasionally, manufacturers may place a sticker under the hood that contains information about the vehicle, including the engine number. Look around the engine compartment for any stickers or labels that may display the engine number.

If you're having trouble locating the engine number, consult the owner's manual or contact a Toyota dealership for assistance. They can provide guidance on where to find the engine number specific to your vehicle.

dark ceramic insulators in plugs is an indication of excessive fuel or oil in combustion
run the fault codes to check for a problem in the injectors/
controls
check for problems in the HT leads
check for the same heat range for all plugs in use ( all plugs have the same numbers on the side )

Year make and model ??

2 wheel drive check dif numbers or 4x4 if 4x4 check dif numbers 4x4 must be the same numbers

check compression, check valve clearance, check injector for properly working, check for vacuum leak around this cylinder.

number four is the cylinder next to the transmission. check spark plug first then wires for carbon trails any breaks or cracks replace wires. check injectors with a noid light.

READING CODES USING MIL (CHECK ENGINE) LAMP

Be advised that the MIL or CHECK ENGINE light can only perform a limited number of functions and it is a good idea to have the system checked with a scan tool to double check the circuit function.

1. Within a period of 5 seconds, cycle the ignition key ON - OFF - ON - OFF - ON .
2. Count the number of times the MIL (check engine lamp) on the instrument panel flashes on and off.

The number of flashes represents the trouble code. There is a short pause between the flashes representing the 1st and 2nd digits of the code. Longer pauses are used to separate individual 2-digit trouble codes.
An example of a flashed DTC is as follows:


Lamp flashes 4 times, pauses, then flashes 6 more times. This denotes a DTC number 46. Lamp flashes 5 times, pauses, then flashes 5 more times. This indicates a DTC number 55. DTC 55 will always be the last code to be displayed.

Fig. Fig. 2: Diagnostic trouble code chart (1 of 2)-1995-97 engines

Fig. Fig. 3: Diagnostic trouble code chart (2 of 2)-1995-97 2.0L engines

For obtaine the PARFT NUMBER W/o head up display, I suggest check here...



Remember, before proceeding with check out, please confirm part number with our customer service at [email protected]

Hope this help.

take the bulb back out and clean inside the bulb holder, there may be some corrosion or other debris in there