SOURCE: location of crankshaft sensor chrysler
Heres adiagram to help you, its located at right rear of motor.
SOURCE: sebring 1997 I need picture to lookat the PCM
On 1997 Chrysler Sebring 2.5L MFI 6cyl...
- the PCM is located in the left side of the engine compartment, beside the Power Distribution Center (PDC).
Fig. 1: Location of the PCM on the Cirrus, Stratus, Sebring convertible and Breeze models
Fig. 2: Location of the PCM on the Sebring coupe and Avenger models
- the Crankshaft Position Sensor is located: under hood, driver side, upper engine area, mounted on end of engine block
Fig. 4: Location of the crankshaft position sensor on 2.5L engines
Hope helps; remember to rating this answer and leave some testimonial comments.
SOURCE: Where is the crankshaft position sensor located?
the crankshaft position senor on the 2.2L is located on the rear right side of the engine block
SOURCE: oil sending unit on 2004 chrysler sebring V6
Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove
SOURCE: 2002 CHRYSLER SEBRING - 2.4LTR DOHC ENGINE I
There on very tight, did you insert a bolt in the hole, where the bolt for the crank bolt goes on, insert a long where it sticks out pass the pulley about 3 to 4 inches, but thinner bolt in there, and the tip of the puller on it, tighten the puller, and it will come out. I would get two of those bolt's, because it will start to bent, and you might need to used the other bolt to finsh taking it out.
Testimonial: "THANK YOU -THANK YOU-THANK YOU !!!! I RECEIVED RESPONSE THIS AM , RIGHT B/4 I WAS TO BEGIN AGAIN AND WITH THIS TIP I HAD THE PULLEY OFF IN 5 MINUTES ."
3,841 views
Usually answered in minutes!
×