Saeco Incanto Rondo - Lower LEFT Red Light Flashing

The sensor is likely defective or needs to be cleaned of mineral buildup.

page 31 and 32 have some light indicators and troubleshooting options. It is a very good manual link as well if you need one. SAECO INCANTO CLASSIC CLASS Operating Instructions Manual Page 5

That light indicate that you need to change the water filter in the tank. The water filter is either an Aqua prima
or intenza filters. If you are not using the filter I would suggest to just reset the light. You can reset the light by holding down the water button under the coffee brew button. Looks like a water drop.

You can also download the manual at www.CeriniCoffee.com

Try to set the machine to grind finer. Common problem with this machine when the grinder grinds too coarse, and the coffee will not fit in the brew unit during the cycle. Grinding finer will allow the brew unit to compress and the machine should complete the cycle.

If this does not work there may be another thing to try, Let me know [email protected]

www.CeriniCoffee.com

open the water valve until it turns off the light, if you go through half the reservoir and it does not work, then the water circuit is clogged.

Hello, This may be the solution for you: having removed the ceramic grinder to clean out the unit, one of the wires on the grinder had become removed (the "center wire") on the connector. The 2 outside wires were sufficient to give me the illusion that the grinder was connected correctly, however it would only run for a half second and then coast to an annoying stop.

Check all 3 wires that connect to the grinder and make sure they are making contact.

I have the same problem. It seems that the group motor issues. I ve opened up and found the group motor is coming some sparks. I know very well Saeco Magic Cappucino , Saeco range is more or less the same, Saeco incanto, first time deal with it , somebody just brought it to me to check it. I might fix it if find parts for it.
Load circuit means a lot, flow meter, pomps, could be the electronc board, bewing unit blocked up with coffee, so basically there is no water in circuit water or is air in water circuit....You have to check everything,

Hello,
Press and hold the hot water botton for 5 sec. and the light will go off; It will light after 1year again, to change the water filter;
BR,

Hi,

I think you have to take it to a Saeco service center, they have to upgrade your power board in the machine.

I found a machine in my dentist's office with this exact same problem. I'm not familiar with the model, so I downloaded a manual for the closest model I could find online (the Sirius), and it offered no help -- but in 8 languages!

I ended up just pulling the drip tray, pulling the box where the grounds end up, and re-inserting the assembly (all while the machine was on.) When I buttoned it up again, it worked.

Hope this helps (although I can see how it might not...)