Fuser Fault How to solve the Code 10-390 and 10-289

You need a Service Call

Fault Code 10-355: A Hard Overheat Fault has been Detected in the Fuser Assembly. The Heat Roll Overheat Thermistor, the External Heat Roll Overheat Thermistor, and the Inlet Roll Control Thermistor all Indicate an Over Temperate Condition.
Aug 13, 2015

Fault Code 10-355: A Hard Overheat Fault has been Detected ...

https://www.support.xerox.com > en-us > article

Fault Code 08-311: Registration Side Shift Motor Fault

https://www.support.xerox.com > en-us > article
Aug 13, 2015 - Fault Code 08-311: Registration Side Shift Motor Fault. Article Id: 1088027 ' Published: 08/13/2015. Product support for.

In 310-380-00 fault on xerox 7855 The fuser delta value between the temperature sensors A and B is to high. Check the fuser module connector and fuser connector assembly for damage. • Check that the photoreceptor fan, PL 90.25 Item 7 is working correctly and that the direction of air flow is into the machine, refer to the 390C Photoreceptor Fan RAP. Check that the intake grille at the rear of the machine is not blocked and there is not a heat source such as a radiator. For the more details visit the link: https://printcopy.info/?l=en&mod=erc&brand=Xerox&model=WorkCentre%205855&code=310-340-00,%20310-350-00,%20310-360-00,%20310-365-00,%20310-380-00

Possibly the same issue on a different model:

Fault Code 010-315: Fuser Latch Contact Fail Try these solutions:

• Make Sure That the Fuser Drawer (Handle 2c and 2d) Magnets are Straight and Tight and That the Door is Closed Securely
• Reseat Fuser Drawer (Transport / Duplex Drawer)
• Power OFF / Power ON the Machine

http://www.support.xerox.com/support/xerox-4595/support/enus.html?objGUID=3869

That is a fuser fault code will need to repair fuser first. If you buy the fuser might come with instructions to reset code.

its a problem with the fuser unit ,its overheating .two ways to solve it first check if the sticker paper is supported by your printer ,2nd you may need to replace the fuser unit

If you have resr the error code in service mode and it did not clear.... Odds are you are going to have to replace the upper fuser heating unit with a new fuser film or you may want to replace the whole fuser unit..... The heating element is shorting out...... Good Luck

Error code E007 on an ir2016 means that the fuser film has a fault. The fuser film is the black sheet that melts the ink into the paper on the final stage of the copy process. It more than likely has ripped apart. You will need to call a service tech for this one.

010-150, 155 Too much or not enough paper in duplex tray 10-300 Fuser thermistor 10-302 Low fuser temperature 010-304 Bad fuser temp 10-308 High fuser temperature or open thermistor 010-310 High fuser temperature 010-312 Fuser not up to temperature after energy save 010-314 Fuser problem 010-320 Fuser web finished 010-330,327 335, 340 Exit switch, vertical sensor switch actuated when power is turned on

foult code 010-348 pleas solve this problem

e000007 is related to the fuser..you need to change the fixing film or clean the sensor