Fronius welders keep getting a error code no h20 on our fronuis welders

Question edited for clarity.
Question moved from Misc Category.

H2o is a water error, is it a Condenser dryer?

https://www.google.com/search?q=Ariston+dryer+TVF75C6H1.+I+have+error+code+H20

No such Indesit code H2! Are you sure it is not H20?

Error H20 in the Indesit washing machine indicated that during the allotted time the machine could not fill enough water for washing or rinsing because of some kind of malfunction.

https://www.fronius.com/en-au/australia/photovoltaics/products/home/inverters/fronius-primo/fronius-primo-3-0-1

I noticed the washed dose this if I run a bath sounds daft but it's like it's not getting enough water feed whilst I'm using water else where and once my bath turns off error message goes away

You may have soap & grease in the pipe that leads to the pressure switch. Remove and flush through and/or replace. dry before refitting.
Thus constant high would give pump faults (thinks machine still contains water). Constant low may cause over filling. If you have a plug that suddenly moves, that can cause the above errors.

Hi from retired Englishman in SW France,
(Quote)
Error code H20
If the machine is not in the demo mode and this error is displayed it means there is no water being supplied to the machine.
To cancel press and hold start/cancel then press again to cancel the drain and the machine should now be reset and display 'ON' as usual.

If your machine IS in demo mode come back to me and I will tell you how to get back to normal mode - it's too long to put in this solution ;-0)

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

I would give Westermans International a try. they have extensive knowledge on service and repairs of Fronius, Kemppi and ESAB welding machines. Try [email protected] and you should sort the error quickly and for free!

try Westermans - used welding machines supplier. They stock the best brands like Lincoln, ESAB, Kemppi and Fronius. They should also have operator manuals for most machines. email them at [email protected] ask for Craig.

if there a advance cycle button push it an see if the timer will advance to spin if not turn the power off to washer an wait a couple mintue an the door will open

This is a plumbing error and not a machine error. H20 means "water turned off or valve faulty"