Replace Fuel Filter - 1994 Geo Prizm

Hi Angela,could be a clogged fuel filter or a bad fuel pump,Here's a link showing you how to replace the fuel filter. Repair Guides Routine Maintenance Fuel Filter AutoZone com Here's another link to a new fuel filter. Duralast Fuel Filter FF651DL ReadReviews onDuralast FF651DL Here's another link on how to replace the fuel pump,change the filter first. Repair Guides Gasoline Fuel Injection System Electric Fuel Pump AutoZone...

Nissan fuel pump recall : Nissan Altima Common Engine ...

repairpal.com > Problems > Nissan > Altima

Nissan issued a recall on the fuel pump for premature failure. ... I am in need of a newfuel pump and scared to drive my car and its leaking ... pump and fuel filter located and how can i access them if i wan to replace th. ... 2000 Nissan Altima.

Fuel pump and fuel filter - 2003 Nissan Altima - RepairPal

repairpal.com > Questions > Nissan > Altima > 2003 Nissan Altima

Mar 25, 2009 - Where is the fuel pump and fuel filter located and how can i access them if i wan to replace them?

Fuel Pump Replacement Cost for Nissan Altima - RepairPal ...

How To Replace Fuel Filter on Nissan Altima 2001 - YouTube? 6:46https://www.youtube.com/watch?v=Vwg2wm13ilMOct 25, 2011 - Uploaded by roluardoHow To Replace Fuel Filter on Nissan Altima 2001 ... How toreplace a 2002 Nissan 3.5 Maxima Fuel Filter 2000-2004 pt 1 - Duration: 14:20.fuel hose replacement. Car fuel leakage. fuel pump ...? 5:30https://www.youtube.com/watch?v=BPGaxxkK71cApr 4, 2014 - Uploaded by LearningZoneHere I am going to illustrate the fuel hoses (fuel lines)replacement for Nissan Sentra ... Fuel pump leak fix - quick and cheap - Duration: 11:16.

Hello kenny,This article is showing the instructions of replacing fuel pump and fuel filter,you can read it ,How to Replace Fuel Pump and Fuel Filter

Are you saying there is no fuel pressure in the line, or just after the filter ? ?
If there is pressure before but not after the filter, the filter is usually blocked.

your vechicle has frame mounted inline filter,fuel filter mounts to the frame above the rear of the fuel tank, the fuel tank has to be loosen and lower down enough to replace fuel filter.first thing you need to do before replacing fuel filter,you need to relief fuel pressure by removing fuel pump relay in the power distribution center.

IF YOU HAVE FUEL FILTER WITH FUEL PUMP ASSEMBLY YOU HAVE TO REPLACE FUEL PUMP ASSEMBLY REMOVE THE REAR SEAT BENCH IN ORDER TO REPLACE THE FUEL PUMP ASSEMBLY. NOW IF YOU HAVE FUEL PRESSURE REGULATOR AND FUEL FILTER AS ONE UNIT.BECAUSE FUEL PRESSURE REGULATOR BUILT TO THE FUEL FILTER.TO REPLACE FUEL FILTER, FIRST DEPRESSURIZE THE FUEL SYSTEM BY REMOVING THE FUEL PUMP RELAY LOCATED ON THE COWL.THEN CRANK ENGINE UNTIL IT DIES LACK OF FUEL.THE CRANK ENGINE OVER FEW TIMES TO MAKE SURE ALL FUEL OUT THE FUEL LINES.LOCATION OF FUEL FILTER UNDER THE VECHICLE MOUNTED TO THE LEFT SIDE OF THE CHASIS.

How to Replace a Fuel Filter in a Chevy
I want to do this! What's This?

A clean fuel filter in your Chevy means clean fuel injectors and a clean fuel pressure regulator. Replace the fuel filter in your every 30,000 to 40,000 miles to keep the fuel system in optimal condition. Follow the instructions provided here to change the fuel filter on a Chevy that does not have a flex fuel system.
Difficulty: Moderate Instructions Things You'll Need:

• Shop towel
• Pressure gauge
• Container for fuel
• Car ramps
• Wrench
• New fuel filter

1. 1 Disconnect the negative battery cable. Relieve the vapor pressure in the fuel tank by slowly loosening the fuel filter cap. Wrap a shop towel around the fuel pressure valve as you connect a pressure gauge to the fuel pressure valve.
   
2. 2 Put the bleed hose of the gauge into a container that will hold the fuel. Open the gauge valve to bleed the system pressure. Drain any fuel that remains in the gauge into the container, as well.
   
3. 3 Raise the vehicle and clean the fuel filter connections and the surrounding areas. Disconnect the fuel pipes and the threaded fittings from the fuel filter. Cover the fuel pipes once they're disconnected, to prevent contaminating your fuel system.
   
4. 4 Slide the fuel filter out of the bracket on the frame rail. Check the fuel pipe O-rings and replace the if you find any cuts, nicks, or distortion. Slide the new filter into the bracket. Remove the caps you put on the fuel pipes and connect the threaded fittings back to the filter. Tighten the fittings to 18 foot-pounds.
   
5. 5 Lower the vehicle and tighten the fuel filter cap. Replace the fuel. Reconnect the negative battery cable. Turn the ignition on for 2 seconds. Turn the ignition off for 10 seconds, the Chevy and check for leaks.
   

Tips & Warnings

• Always let the pressure out of the fuel system before you disconnect the fuel lines. Do this carefully so as not to spray fuel on your skin, face or eyes.
• Make sure you wipe up any fuel that may have spilled while you were replacing the filter.

the fuel filter is inline with the fuel line in front of the fuel tank. Inside the tank is a sock that filters the fuel in the suction pipe to the fuel pump also That sock filter is always replaced upon replacing the pump only.

If the fuel filter is mounted inside the fuel tank at the pump it does not need replacing and is a permanent filter. All you have to do it follow the fuel lines from the fuel tank to the engine. If the filter is mounted in the fuel line you will find it.

go here for help on villager issues

http://autos.groups.yahoo.com/group/villagerquest/

It's unde the hood, on the firewall, on the driver side.

Fuel Filters In-Tank
Removal and Installation
The in-tank fuel pump filter is not serviced separately. To service the fuel pump filter, replace the fuel pump (9350). Refer to the procedure in this section. In-Line
Removal
The following illustration is an exploded view of the fuel filter (9155).


Item Part Number Description 1 9K299 Fuel Filter Upper Hose 2 9A335 Fuel Filter Bracket 3 — Fuel Hose Clamp 4 9C323 Fuel Filter Lower Hose 5 9155 Fuel Filter 6 — Fuel Hose Clamps

1. Relieve the fuel system pressure. Refer to the procedure in this section.
   

1. Remove the fuel hose clamps.
   

1. Disconnect the upper and lower fuel filter hoses from both ends of the fuel filter. Plug the fuel hoses to prevent leakage and contamination.
   

1. Remove the fuel filter from the fuel filter bracket (9A335).